In this set are two Macros 'RG 3D' will turn a pair of frames into a single image to view through Red and Green spectacles it is easy to modify for any colour glasses. 'Pair from Stack' generates a Sterio Pair from a single stack, the output from this macro can be fed into the first macro. See the CombineZM Help for more info on 3D images.
The Left and Right frames must be next to each other in the stack, the left at the lower positiion.
1. Make the Left frame Active
2. Macro->RG 3D
3. View the screen through your spectacles. Hold the 'Shift' key down and press the 'Left' or 'Right' arrow to adjust the positions of the Red and Green components
4. The 'Right' and 'Left' arrows without 'Shift' are used to set the proportions of Red and Green.
5. Press 'Escape' when the picture looks right.
6. Press 'A' twice to mark a clean rectangle for saving.
7. File->Save Rectangle As. The output is in Out
This works best if there are quite a few frames in the stack. Load your frames but do not Stack them.
1. Macro->Pair from Stack
2. Set 'Offset', found by trial and error.
3. Set 'Sharpening', if too sharp make higher, if not sharp enough lower it, the range is 0 to 1000.
4. 'OK'
5. The frames produced will be at the top of the stack, if they do not look right delete both and go back to 1 altering 'Offset' and/or 'Sharpening'.
6a. Either Press 'A' twice and File->Save Rectangle As
OR
6b. Run 'RG 3D' as above.